maximum pressure
英 [ˈmæksɪməm ˈpreʃə(r)]
美 [ˈmæksɪməm ˈpreʃər]
网络 最大注塑压力; 最大压力; 最高压力; 最大胎压; 最大壓力
双语例句
- Many think it was timed deliberately to place maximum pressure on Fifa president Sepp Blatter before Friday's crucial vote on his presidency, which he won.
许多人认为这是蓄意向国际足协主席SeppBlatter施压，而他正面临着周五的至关重要的主席人选的投票（最后还是成功连任）。 - Check that the hydraulic installation is able to withstand the maximum pressure engraved on the accumulator.
确认所连接的液压设施可承受储能器所标明的最大压力。 - When design temperature or MDMT cannot coincide with the maximum pressure, the corresponding design pressure shall be designated together with the temperature.
当设计温度或最小设计金属温度与最大压力不符，应根据温度指定相应的设计压力。 - This is the maximum pressure you should use when massaging baby.
这是最大的压力，您应该使用时，按摩的婴儿。 - Never exceed the maximum pressure or flow ratings of any component in your system the component with the lowest rating determines the maximum performance available from your system.
不要超过你所选择的水泵系统中任何部件的最大压力或流量的额定值；额定值最低的部件决定了水泵系统的最佳可用性能。 - The root of herbaceous peony still has composed, demulcent, solution is hot, fight phlogistic, fight ulcer, reduce portal vein maximum pressure, reduce serum bilirubin, outspread heart coronary artery, restrain plaque to gather, fight bacterium to fight virus action.
赤芍还有镇静，镇痛，解热，抗炎，抗溃疡，降低门静脉高压，降低血清胆红素，扩张心脏冠状动脉，抑制血小板聚集，抗菌抗病毒作用。 - It means that on the production side, there is maximum pressure to conserve the use of those scarce productive resources.
它意味着出产一方受到最大限度的压力要它节约使用有限的出产资本。 - The paper studies the influence of propellant thickness on the interior ballistic performance of an equilibrium launcher, such as, probable error of muzzle velocity, maximum pressure.
该文研究了某平衡抛射武器发射药厚度对其初速或然误差、最大膛压等内弹道性能的影响。 - Separated pressure control for the jet system allows maximum pressure and flow control of chosen parts at the body a unique IQUE feature.
喷水系统的压力可单独控制，使得身体相应部位的最大压力和流量控制在IQUE特征值范围内。 - Permissible mean maximum pressure
容许的最大平均压力 - A method for optimizing the main dimensions of a cam-oscillating follower mechanism in common follower motions is presented with the MATLAB, which maximizes the cam volume and maximum pressure angles.
以MATLAB为辅助工具，给出了摆动推杆盘形凸轮机构在基本推杆运动规律时的基本尺寸优化设计方法，使凸轮机构的体积和最大压力角达到最小。 - For all elements other than flow elements or control valves, the true minimum, normal and maximum pressure and temperature ranges over which the element is expected to be effective are shown.
对于所有元件（流量元件或控制阀除外），列出了元件预计起作用范围内的实际最小、正常和最大压力与温度？ - Maximum pressure differential required for valves with lever actuators should not exceed the limits listed.
采用杠杆执行器要求阀门的最大压差不能超过下表所列的极限。 - A test to determine the maximum pressure integrity of exposed formations at the casing shoe.
确定套管鞋处裸眼地层最大破裂压力的试验。 - However, other aspects of sucking, such as suck width and maximum pressure, did not differ significantly between the groups.
然而吮吸的其他方面如吮吸的宽度和最大压力没有组间差别。 - Since a combustion means is also used, there is no possibility of the maximum pressure dropping during actuation.
由于还使用一种燃烧剂，因此，不存在启动期间最大压力降低的情况。 - The results show that the maximum explosion pressure and the maximum pressure rising rate are proportional to the initial pressure.
结果表明，最大爆炸压力和最大压力上升速率均与初始压力呈正比。 - We can get experiential functions of maximum thrust to revolution and of maximum pressure to revolution with data-fit method.
通过对计算数据拟合得到了最大推力与转速、最大压强与转速的经验公式。 - The variance analysis method is used to process a lot of test data by gun shooting. The influence of the initial random parameters of interior ballistics on the maximum pressure and probable error of muzzle velocity is studied by the statistic analyse.
利用靶场提供的大量试验数据，用统计学中的方差分析法，对内弹道过程中一些初始参量在随机波动时对最大膛压和初速或然误差影响的显著性进行了统计分析。 - On the basis of the digital simulation of internal ballistic properties for a solid rocket motor, the mean value and variance of internal ballistic properties are given, such as, average pressure and thrust, maximum pressure, specific impulse and total impulse.
对某固体火箭发动机的内弹道性能进行了数字仿真，得出了燃烧时间平均压强和平均推力、最大压强、比冲和总冲等内弹道性能参数的均值和方差。 - The maximum pressure of the field is on the verge.
并且整个流场中的最高压力就产生在这个边界上。 - The influences of the maximum pressure, the average velocity and the slide-roll ratio on the yield thickness are discussed in detail.
本文还给出了用膜厚形式表示的屈服准则，并详细讨论了最大压力、平均速度和滑滚比对屈服膜厚的影响。 - Determination of steam parameters and maximum pressure of medium and low temperature waste heat boiler
中低温余热锅炉蒸汽参数与最大压力的确定 - In this paper, the maximum pressure distribution in various working condition was analyzed and studied, which provides a foundation for optimization design of pipelines under complicated topography and for reasonable selection of pipe materials and calculation of pipe wall thickness.
本文对各种工况下的最大压力分布作了分析研究，为复杂地形下管线的优化设计、合理地选择管材和计算管壁厚度提供了依据。 - Based on the indicator diagrams obtained, the maximum pressure in cylinder and heat release rate after adding additive were analyzed.
基于实测的示功图，对生物添加剂加入油品后最大缸内压力和燃烧放热率等方面做了发动机燃烧特性分析。 - The maximum pressure, the maximum friction coefficient and the highest film temperature all occur in the vicinity of pitch point.
齿轮啮合过程中的最大油膜压力、最高油膜温升和轮齿间摩擦因数最大值都发生在啮合节点附近。 - Propellant web size and charge weight are important random factors, which affect gun maximum pressure.
火药弧厚和装药量是影响火炮最大膛压的两个重要的随机因素。 - Hydrocyclone work effectively has the request of minimum and maximum pressure, minimum and maximum flow.
旋流器有效工作有最小压力和最大压力，以及最小流量和最大流量的要求； - Maximum pressure value decay process is not monotonous, and has fluctuations.
最大压力值在衰减过程中不是单调衰减，有起伏。